How to use the AccuPro 360ST spreader

The AccuPro 360ST is a high-precision rotary spreader designed for the application of seed, fertiliser, and other free-flowing materials to turf.

To maximise the effectiveness and longevity of your AccuPro 360ST, follow the guide below.

Step 1: Pre-use inspection

Before using the spreader, ensure it is clean and free of debris from prior usage by conducting a thorough inspection.

Step 2: Material check

Ensure the material to be used is in good condition, free-flowing, and compatible for use in a precision rotary spreader.

Step 3: Setting the aperture

1. Ensure the on/off lever is in the closed position.
2. Select the correct setting on the SmartSpread™ by choosing the letter corresponding to the fertiliser being applied.
3. Select the desired application rate on the 1 to 25 scale located on the handle by locking the setting screw at the corresponding number.
4. Further information on application rates of specific ICL products can be found on ICL websites or through ICL-appointed retailers.

Step 4: Filling the hopper

1. Ensure the control lever remains in the off/closed position before filling.
2. Fill the hopper uniformly.
3. Always fill the hopper in a safe location away from areas where accidental spillage could cause damage.

Step 5: Spreading material

1. Push the spreader at a brisk walking speed of approximately 5 km/h, always keeping the impeller parallel to the ground.
2. With the upper gauge and the SmartSpread™ lower gauge set in the desired positions, push the handlebar on/off lever forwards to the setting stop, while simultaneously starting forward motion.
3. Always begin moving forward at the same time as pushing the lever forward to the on position.
4. At the end of each run, pull the on/off lever back to the zero position to stop material flow and cease spreading.
5. The spread width of the material varies with different fertiliser types. Always check the spread width of the product to ensure correct spread distances. Detailed information on the spread width of specific fertilisers can be found on the ICL websites or through ICL appointed retailers.

Step 6: Cleaning and after-use instructions

Always empty any leftover product from the spreader when the application is complete, disposing of any excess material correctly. The best way to empty unused material from the hopper is by inverting the spreader. Further action may be required to clear any remaining material if necessary.

Wash the hopper thoroughly with clean water particularly around the agitator and the underside of the hopper. Drying of excess water is recommended. Do not reuse the spreader until it is dry.